![]() Is there a diagram anywhere that shows how the hoses are supposed to be routed (in case I have them backwards), because I think I have the hoses right, but I am only human. ![]() ![]() ![]() What could I be missing? What else can I check/change/repair/replace? This has occurred at every turn in the process, and still persists. When pushed, the fuel will run the motor until the amount of fuel in the carburetor wanes, then if left alone, it will die out. The persistent issue is that when it starts, it won't hold a low idle, nor will it stay running unless the primer bulb is pushed continuously. I have attempted to adjust the idle with the old carburetor, but not with the new one (assuming that it's set to factory standards). I have so far replaced the piston, ring and cylinder assembly, spark plug, hoses, gaskets and carburetor. It had pure gasoline run through it, and it would no longer start. I was given a Stihl TS420 Cutting Saw to fix.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |